Table of Contents
Advertisement
Setting Bass Focus
Using the previously specified delay number (time difference) allows
you to set a time difference between the front-rear/left-right speakers.
Namely, it enables a time correction based on your preference. With an
initial delay of 0.05 ms for each of the 0 to 400 steps, audible time
correction can be achieved.
6
Set the delay number in the front and rear, and on
the right and left of the desired speaker by touching
the respective [ ] or [ ] button.
• Any setting in Bass Focus is applied in time correction, too.
• Touch [RTN] to return to the previous screen.
Speaker Setup
The PXA-H700 or PXA-H701 can be set according to the playable
frequency range of your speakers.
Check the playable frequency range of the speakers (not including the
subwoofer) before performing this operation to verify whether the
speakers can play low frequencies (of about 80 Hz or less).
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is cancelled if Decode mode is switched.
1
Check that Defeat mode is off (pages 26, 27).
2
Press SETUP.
The SETUP selection screen appears.
3
Touch [
] of i-Personalize.
The i-Personalize screen will appear.
4
Touch [
] of A.PROCESSOR.
The A.PROC list screen appears.
5
Touch [
] of SPEAKER SETUP.
The adjusting screen of SPEAKER SETUP appears.
6
Select the speaker characteristic by touching [ ] or
[ ] of the desired speaker setting.
1
OFF*
:
When no speaker is connected.
SMALL:
When a speaker that cannot play low frequencies
(80 Hz or less) is connected.
2
LARGE*
: When a speaker that can play low frequencies (80
Hz or less) is connected.
1
*
It is not possible to set the front speakers to "OFF".
2
*
If the front speakers are set to "SMALL", the rear and
centre speakers cannot be set to "LARGE."
46
-EN
• If the centre speaker is turned "OFF," the centre channel's audio
signals are added to the audio signals output from the front speakers.
• The Subwoofer can be set only to ON/OFF.
• If the centre speaker is turned "OFF," the center channel's audio
signals are added to the audio signals output from the front speakers.
• If you set the speaker response to "OFF," also set the speaker setting
to "OFF." (page 42)
• Perform the setup for all the speakers ("Front," "Center," "Rear"
and "Subwoofer"). If not, the sound may not be balanced.
• When centre is set to "OFF", the setting is ineffective even if centre
is set with this function.
• Through changing the settings on each speaker, a change in the
output of the other speakers may occur due to the setting
requirements.
• When using the PRO LOGIC II, if the rear speaker is set to
"LARGE", then there will be no output from the subwoofer.
Setting of Dolby Digital
1
Check that Defeat mode is off.
2
Press SETUP.
The SETUP selection screen appears.
3
Touch [
] of i-Personalize.
The i-Personalize screen will appear.
4
Touch [
] of A.PROCESSOR.
The A.PROC list screen appears.
5
Touch [
] of MULTI CH SETUP.
The MULTI CH SETUP display appears.
Set the items below as you desire.
Adjusting the acoustic image
(BI-PHANTOM)
In most installations, the centre speaker must be placed directly between
the front passenger and driver. Using this function, the centre channel
information is distributed to the left and right speakers. This creates an
acoustic image simulating a centre speaker directly in front of each
listener. Adjusting the centre width in PL II MUSIC (see "Using the Pro
Logic II Mode," page 48), makes this function ineffective.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is cancelled if the Decode mode is switched.
Touch [
] or [
] of BI-PHANTOM to adjust the level.
The level can be adjusted within the range of -5 to +5. The
higher the level, the more the position of the centre speaker is
shifted to the sides.
The BI-PHANTOM function is turned off by touching [OFF].
• This adjustment is effective when the setting of the centre speaker to
SMALL or LARGE in the speaker setup settings.
• This adjustment is ineffective when the speaker is set to CENTER
OFF in "Setting the Speakers" (page 42).
Hide quick links:
Advertisement
Table of Contents
