Rear Selection Function; Switching Display Modes; Switching The Visual Source Only (Simultaneous Function); Cancelling The Simultaneous Function - Alpine IVA-D100RB Owner's Manual

Rear Selection Function

While listening to the radio or other audio source, at the same time,
pictures in a disc inserted in the IVA-D100R/IVA-D100RB can be
enjoyed in the rear monitor. However, only pictures are output, not
sound.
1
Press SETUP.
The SETUP selection screen is displayed.
2
Touch [ ] of REAR SELECT.
Rear Select display appears.
• This function cannot be used when "Setting the Picture Output"
(page 37) is set to OFF in the SYSTEM SETUP.
3
Touch [ ] of the desired source such as visual
(auxiliary input, built-in DVD, etc.) to select.
• Touch [OFF] to cancel the rear entertainment function.
• When the "Setting the AUX Mode" (page 37) is set to OFF, the
auxiliary source is not displayed.

Switching Display Modes

While your vehicle is parked, touch [WIDE] on the visual
source screen or press BAND on the unit.
Each touch changes the display modes as follows:
MODE 1 MODE 2
(WIDE) (CINEMA) (NORMAL)
In Mode 1 (Wide), the monitor displays a normal picture wider to
fit in a wide-screen monitor by evenly stretching out the picture
horizontally.
In Mode 2 (Cinema), the monitor displays a normal picture by
stretching out the picture horizontally and vertically. This mode is
good for displaying a cinema type picture at the 16 : 9 ratio.
In Mode 3 (Normal), the monitor displays a normal picture at the
centre of the screen with a vertical black band at each side.
28
-EN
MODE 3 MODE 1
(WIDE)
Switching the Visual Source Only
(Simultaneous Function)
You can watch the video portion of another source while listening to the
current source.
1
Press VISUAL on the unit.
The VISUAL selection screen appears.
2
Touch [ ] of a desired visual source.
The visual source is switched to the selected one.
The visual indicator lights up.

Cancelling the Simultaneous Function

1
Press VISUAL.
2
Touch [ ] of NORMAL.
The simultaneous function is canceled.
The visual indicator goes out.
• To apply the setting, set to VISUAL in "Setting the VISUAL Button"
(page 37).
• If a DVD player is connected, you can receive the DVD picture.
DVD changer (DHA-S680P) is connected:
Press and hold V.OUT on the remote control supplied with the DVD
player or DVD changer for more than 2 seconds. The picture of the
DVD will be output.
The DVA-5210 is connected:
Press V.OUT on the remote control (included with the DVA-5210) to
output DVD picture.
• The simultaneous function cannot be used when the Audio source is
in the navigation mode.
When NAV. is set in "Setting the VISUAL Button" (page 37), only the
navigation screen can be recalled.
• When the "Setting the AUX Mode" (page 37) is set to OFF, the
auxiliary source is not displayed.