NEC SuperScript 950C User Manual page 44

Printer is Not Powered
Indicator Light is not illuminated
• Check that the printer is properly connected to the
power socket.
• Press Power button .
Failure Condition
This error is identified by the following
• Very rapid flashing of the light indicator.
• Message from the Printer Monitor such as Carriage defect
or EPROM defect.
Try switching the printer off then on. If the problem persists
call technical support.
No Printer Reaction
There is no reaction when you switch the printer on.
• Check that you have connected the printer power cable
properly, both to the printer and to the electrical power
socket.
• With the Printer Cover open, press power button
• Check that the Print Cartridge Carriage moves slightly
when you switch the printer on. If not, call technical
support.
• Try switching the printer off and then on again. If
nothing happens disconnect the printer and call
technical support.
40 SuperScript 950C— User's Guide
Demo Page Did Not Print
If the Indicator Light is flashing, check that you have
installed both print cartridges and loaded some paper in one
of the paper trays.
If you tried printing the Demo Page from the Printer
Operator Panel:
• Check that you have executed the sequence correctly by
holding down the power button
paper button four (4) times; then release both buttons
simultaneously.
• Press the power button
a few seconds, then press the power button
If you tried printing the Demo Page from the Printer
Monitor:
• Check if a message is displayed on your Printer
Monitor. If there is, depending on its content, perform
the required operation.
• Try printing the Demo page again.
. If you still cannot print the Demo Page, try printing the
windows Test Page (from the General Tab) to check if the
driver has been correctly installed and that you do not have
any problems with printer cable connection.
and pressing the
to switch the printer off, wait
again.