Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have nished.
Fig.7-7
Fig.7-8
Fig.7-9
Fig.7-10
B
A
INSTALLATION
B
A
28
Lowering the Two Rear Rollers
To adjust the height of the rear of the range, rst t a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig.7-7).
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Note that the rollers are only intended to aid installation – the
range should not be moved once it is installed.
Completing the Move
Grip under the fascia panel and lift the front of the range
slightly. Carefully position the range close to its nal position,
leaving just enough space to get behind it (Fig.7-8).
DO NOT use the door handles or control knobs to
n
n
maneuver the range.
IMPORTANT: Remove all tape and packaging. Make sure
the burner heads are properly seated and level. Take the
accessory pack out of the oven. Check to be sure that no
range parts have come loose during shipping.
Installing the Flue Grille
The ue grille is packed separately. Locate the grille onto the
ue and secure to the cooktop with the 5 screws supplied
(Fig.7-9).
Leveling
It is recommended that you use a spirit level on a rack in the
oven to check for level.
Place the range in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the range or the units.
The front feet and rear rollers can be adjusted to level the
range. To adjust the height of the rear of the cooker, use a ½"
(13 mm) spanner or socket wrench to turn the adjusting nuts
at the front bottom corners of the cooker. To set the front feet
turn the bases to raise or lower.
Anti-Tip Device
WARNING: The range must be secured by the anti-
n
n
tip bracket supplied. Unless properly installed, the
range could be tipped by leaning on the door. Injury
might result from spilled hot liquids or from the
range itself.
When tting an anti-tip device please refer to the instructions
supplied with the device for further details on tting.
Note: The range must be set to the correct height and leveled
before the anti-tip bracket is installed.
Floor Fixing
Using the screw supplied, assemble the anti-tip bracket base
and anti-tip bracket extension (Fig.7-10).
Using suitable screws and xings, attach the assembled anti-
tip bracket to the oor to give a su cient engagement into
the back of the range.
Advertisement
Table of Contents
