Table of Contents
Advertisement
The event configuration configures the actions for each event type. Local section configures the
actions for events from local (self) system, and configuration activates local devices and a Remote
section configures the actions for events from remote (peer) system.
The following table lists the possible actions for events.
Action
Beep
Alarm1/Alarm2
E-mail
FTP
Preset
Sensor1 / Sensor2
Configure the actions when the sensor 1 or 2 is activated. Multiple actions can be set for a
single event.
On Video Loss
Configure the actions when video input signal is lost. Multiple actions can be set for a single
event.
On Motion
Configure the actions when motion is detected. Multiple actions can be set for a single event.
On Disconnect
Configure the actions when the link (connection) with peer system is disconnected. Multiple
actions can be set for a single event.
Alarm and Beep activation duration
Set the duration of alarm or beep activation in case of an event. If it is set to continuous, it will
be in active state until an operator reset it manually.
Description
Outputs beep sound using the buzzer in the
system
Triggers alarm (relay) port
Sends E-mail to the specified address. AVI file
can be attached
Upload AVI file to a specified FTP server
Moves the PTZ to associated preset position
-31-
VT-IPSD102H Manual
Advertisement
Table of Contents
