Table of Contents
Advertisement
2. Installation
1. Connecting Video
Encoder System
-
Connect the camera video output line to the encoder VT-IPSD102H video input port.
Decoder System
-
Connect the monitor video input line to the decoder VT-IPSD102H video output port.
2. Connecting Audio
Audio is bi-directional in any configuration regardless of the system mode. If necessary, it can be
configured to be in transmit-only, receive -only or bi-directional mode.
- Connect audio input and output ports to audio devices accordingly.
- Audio signal is in line level, therefore, microphone or speaker with amplification function should
be used.
3. Connecting Serial Ports
For camera control, the PTZ controller (keyboard) and receiver can be connected to serial ports. Two
corresponding serial ports in encoder and decoder which are connected in 1-to-1 fashion works in
pass-through mode. This means that commands at a local system's COM1 port will be transparently
passed to the remote system's COM1 port. Also, a command at a local system COM2 port will pass to
the remote system's COM2 port.
4. Connecting Sensor and Alarm
Connect sensor and alarm devices to corresponding terminals.
5. Connecting Power
After confirming the power source, connect power adaptor and connect the 12VDC connector to the
system.
-12-
VT-IPSD102H Manual
Advertisement
Table of Contents
