Remote Video Monitoring - Vitek VT-IPSD102H Manual

2. Remote Video Monitoring

There are two ways to view the remote video when the connections are completed between a site and
center system. In order for a proper operation, an IP address must be set accordingly.
 Video Monitoring with Decoder System
Once the encoder IP address is set in the remote IP address section of the decoder, the decoder
system will connect to the encoder system and start receiving the video images. Normally, a monitor
connected to the decoder will display video images.
 Video Monitoring using Internet Explorer
If the VT-IPSD102H's IP address is entered in Internet Explorer, the system will ask for confirmation to
install Active-X control. Once authorized, Internet Explorer will start to display video images from the
encoder as shown below.
http://192.168.10.100
 Video Selection
If Primary is selected, Max. 720 x 480 (NTSC) or 704 x 756 (PAL) via H.264 compression
algorithm video can be displayed. And once activated Dual Video compression and Secondary
may be selected, H.264 or MJPEG compression algorithm video can be displayed in this case.
.
 Screen Size:
Adjustable Screen Size
 Digital Zoom:
Max 5x Digital Zoom is available.
-15-
VT-IPSD102H Manual