Table of Contents
Advertisement
4. Remote Configuration
1. Remote Configuration
The server can be configured using a web browser. Type the IP address of VT-IPSD102H in the
address input area of Internet Explorer, then a live viewing screen will be displayed. Press Setup
button located in the upper right area of the monitoring screen, then the server setup page will be
displayed.
Enter IP Address
The remote configuration window may be slightly different depending on the system modes (Encoder,
Decoder). The general explanation of the configuration in this manual is based on Encoder system
and differences according to the modes will be clarified when needed.
The configurations are grouped into 8 categories: System, Video, Audio, Network, Serial, Event,
Preset and User. No configuration changes are applied until Apply is pressed. Leaving the page
without pressing Apply will discard any changes.
2. Encoder Configuration
While most configuration items are common for Encoder, Decoder and Duplex mode, there are items
that are relevant to specific system mode. All the configuration items for Encoder mode were
explained first. Then, items specific only to Decoder and Duplex modes are described respectively.
Sections for Decoder and Duplex will not include items common for all modes.
Press Setup button
-17-
VT-IPSD102H Manual
Advertisement
Table of Contents
