Checking Operating - Vitek VT-IPSD102H Manual

6. Checking Operating

Once the power is supplied to the camera, it will start booting. The system will boot up to an operating
mode after approximately 40-60 seconds. The green LED on the Ethernet port will flash indicating the
system is ready.
Software provided on the disc called ENVI VMS allows you to check the IP address and other network
details of the camera.
 Encoder LED Display
PWR STATUS LINK
Green OFF
Red
Blinking
The above LED status display shows that neither camera or decoder are connected. Once the
encoder is connected to a decoder, the color of link LED will light in green and the LED will blink as
video or audio transmissions occur.
 Decoder LED Display
PWR STATUS LINK
Green
Red
Red
Blinking
Blinking
The above LED status display shows that the encoder has started without connecting to an encoder.
Once an encoder is connected, the color of link LED will be changed to green and the LED will blink
as video or audio data transmissions occur.
DATA
OFF
DATA
OFF
-13-
VT-IPSD102H Manual