Assembly - ProForm 18.0 Re Elliptical Manual

ASSEMBLY

•• To hire an authorized service technician to
assemble this product, call 1-800-445-2480.
•• Assembly requires two persons.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you  nish all assembly steps.
•• Left parts are marked “"L”" or “"Left”" and right parts
are marked “"R”" or “"Right.”"
1. Go to www.proformservice.com/registration
on your computer and register your product.
•• activates your warranty
•• saves you time if you ever need to contact
Customer Care
•• allows us to notify you of upgrades and offers
Note: If you do not have Internet access, call
CUSTOMER CARE (see the front cover of this
manual) and register your product.
2. Remove and discard the shipping brackets (not
shown) on the front and rear of the Frame (1).
Identify the Front Right Stabilizer Tube (145),
which has a Wheel (34) in the indicated location.
While a second person lifts the front of the
Frame (1), insert some packaging materials (not
shown) under the Frame. Have the second per-
son hold the Frame to prevent it from tipping.
Attach the Front Right Stabilizer Tube (145) to
the Frame (1) with three M10 x 20mm Screws
(91) and three M10 Split Washers (105).
Attach the Left Front Stabilizer Tube (not
shown) in the same way.
Then, remove the packaging materials.
•• To identify small parts, see page 7.
•• In addition to the included tool(s), assembly
requires the following tool(s):
one Phillips screwdriver
one rubber mallet
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
2
8
1
145
34
105
105
91