Gateway 7210 System Manual page 69

Expansion card
retention clip
7
Place the replacement card in the slot and press it firmly into the
connector.
8
Once the card is securely placed, slide the card guide release tab down
again (for full-length expansion cards) and press the expansion card
retention clip through the back panel until it clicks into place to secure
the card.
9
Connect any cables to the card (see card documentation for proper cable
orientation).
10
Close the case. (See "Closing the case" on page 27.)
11
Reconnect the peripherals and the power cord, then turn on the system.
You may need to reconfigure the server after replacing an expansion card. You
may also need to install upgrade software that came with the card. Check the
card documentation for additional information.
62
Replacing and Adding Internal Devices
Card guide
release tab