Adding Another Camera: Working With Iphone /Ipad; Procedure For Resetting The Camera - Motorola Blink1 User Manual

Tap Cameras to return to the Camera list.
Tap on to add another camera to the list.
• Tap on Edit:
• Tap Remove to take a camera off the list.
Tap Rename to give a camera a new name.
•
• Tap Alert Settings to receive notifications if a noise is
detected or the temperature in your baby's room is too high
or too low.
• If you use Alert Settings, under Settings on your iPhone
iPad ® , select Notifications > Baby Cam > Notification Center
ON.
• Select your preferred Alert Style and return to the application
and tap Done.
• Tap Cancel to return to the camera list.
• Tap on Account to change the password.
Tap on Logout to leave the account.
•
Adding another Camera: Working with iPhone
30 30
BLINK1_USA_V3_2013_04_18.indd 30-31
4.7 Adding another Camera:
Working with iPhone
Follow the same steps as under 3.3 User Account and
Camera Setup, Working with iPhone

5. Procedure for resetting the Camera

Note: If your camera is moved from one router (e.g. home) to
another router (e.g. office) or you have camera setup issues,
then this camera must be reset again, and then the camera set
up again for devices for Android
1. Switch the ON/OFF switch to ON.
2. Press and hold the RESET button on the underside of
the camera for 5 seconds, until you hear a beep sound.
3. Release the RESET button and wait for the camera to
complete the internal reset procedure.
4. After about 60 seconds you will hear two short beeps and
the green LED starts blinking.
• Please be patient, it may take a few minutes until your camera
appears in your Wi-Fi
® /
/iPad Procedure for resetting the Camera
® ®
/iPad
® ®
® /iPad ® .
TM or iPhone ® /iPad ® .
® devices list, or is added to your account.
31 31
18/4/13 2:09 PM