Auto Revert Choices; Figure 24: Trimming Fader Moves With Auto Revert Enabled; Figure 25: Trimming Pod And Encoder Moves With Auto Revert Enabled - Tascam DM-3200 Manual

4 – Operation : Trimming Mix Moves

Auto Revert Choices:

With AUTO REVERT — TRIM enabled, the automation
system stops trimming mix moves automatically per
control without the need to stop trimming manually.
In this case, controls stop trimming mix moves at dif-
ferent times, depending on when they were released
(faders) or when movement ended (POD controls), or
when the timecode was stopped.
In the case of the touch-sensitive faders, the revert
starts when the fader is released. In the case of POD
controls and encoders, revert starts when the
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-9
-12
Raise Fader

Figure 24: Trimming fader moves with Auto Revert enabled

+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-9
-12

Figure 25: Trimming POD and encoder moves with Auto Revert enabled

28
TASCAM DM Automation Guide
CONTROL
Existing Fader Move
1 sec
2 sec 3 sec 4 sec
1 sec
2 sec 3 sec 4 sec
Hold Fader
Existing POD Move
1 sec
2 sec 3 sec 4 sec
1 sec 2 sec 3 sec
4 sec
POD Movement
Move POD
SENSE TIME OUT has expired without movement of the
control. CONTROL SENSE TIME OUT
trols to respond as if they are touch-sensitive even
though they are not.
When a Revert occurs, the control smoothly matches
back to its previous data based on the amount of
Revert Time set. That previous data could be a con-
trol's Static position or a control's Dynamic mix
moves. See the diagrams below to understand how
this works:
7 sec
5 sec 6 sec
Mix Move
7 sec
5 sec 6 sec
Revert
Time
Release Fader or Stop Timecode
5 sec 7 sec
6 sec
Mix Move
5 sec 6 sec 7 sec
Revert
Time
Control
Sense
Timeout
Release POD Time out or Stop Timecode
allows the POD con-
8 sec
8 sec
8 sec
8 sec