Write To End; Figure 17: Write To End Over Previous Static Fader Position; Figure 18: Write To End Over Previous Dynamic Fader Moves - Tascam DM-3200 Manual

Write To End:

When the Write Revert Time is set to ∞
essentially telling the automation system to maintain
a control's last setting from the point where the auto-
mation recording ends, all the way to the end of the
program. This is called Write To End. In this case,
any mix moves existing in the time between the end
of automation recording and the end of the program
will be erased.
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-9
-12
Touch Fader

Figure 17: Write to End over previous Static fader position

+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-9
-12

Figure 18: Write to End over previous Dynamic fader moves

4 – Operation : Writing Mix Moves
s , you are
Existing Static Fader Position
1 sec
2 sec 3 sec 4 sec
Mix Move
1 sec
2 sec 3 sec 4 sec
Fader
Movement
Release Fader
Existing Fader Move
1 sec
2 sec 3 sec 4 sec
Mix Move
1 sec
2 sec 3 sec 4 sec
Fader
Movement
Touch Fader Release Fader
NOTE
A Write/Trim to End operation must be completed by
stopping the timecode. Manually disabling Write or
Trim mode while timecode is running will not perform a
Write To End operation.
AUTO REVERT must be enabled to use Write To End.
See the diagrams below to understand how this
works:
7 sec
5 sec 6 sec 8 sec
7 sec
5 sec 6 sec 8 sec
Stop Time Code
7 sec
5 sec 6 sec 8 sec
7 sec
5 sec 6 sec 8 sec
Stop Time Code
TASCAM DM Automation Guide
21