Initial Status; Editing The Initial Status; Figure 30: Initial Status And Dynamic Data - Tascam DM-3200 Manual

4 – Operation : Initial Status

Initial Status

The Initial Status of a control is its value before the
first dynamic mix move is present. Until dynamic
mix moves are written to a control, there is no differ-
ence between the Initial Status of the control and its
Static position.
+12
+6
+3
0
-3
-6
-12
Initial Status
Initial Data
All parameters which may be stored in a snapshot are
stored as Initial Data.

Editing the Initial Status

Once a control is in Dynamic mode, any new mix
moves written to that control will be dynamic mix
moves. If it becomes necessary to alter a control's
starting point before the first dynamic move written,
Initial Edit is used.
1 While holding
SHIFT
to enter Initial Edit mode. The automation
system will stop reading dynamic data and all
controls will snap to their Initial Status
positions.
32
TASCAM DM Automation Guide
1 sec
2 sec 3 sec

Figure 30: Initial Status and dynamic data

, press
INITIAL EDIT/ EDIT
When dynamic mix moves are written to a control,
that control is no longer in Static mode. It is in
Dynamic mode. Any change to the mix data on such
control takes into account both the Initial Status of
the control and any Dynamic data present.
7 sec
4 sec 5 sec 6 sec
Dynamic Data
2 Adjust any control to change its initial status.
In the case of switches, pressing a switch while
in Initial Edit mode will change its Initial Sta-
tus to reflect its new setting.
Hold and press
SHIFT
to return all controls to their unedited Initial
Data values while remaining in Initial Edit
mode.
Hold SHIFT and press
exit Initial Edit, saving changes.
8 sec
INITIAL EDIT/ DISCARD
INITIAL EDIT/EDIT to