Auto Revert Choices; Figure 21: Writing New Switch Events Over Previous Switch Events With Auto Revert Enabled - Tascam DM-3200 Manual

4 – Operation : Writing Switch Events

Auto Revert Choices:

With AUTO REVERT — WRITE/TRIM
tion system stops recording switch events automati-
cally on a per control basis, without any need to end
writing manually. In this case, keys stop recording
switch events at different times, depending on when
they were last pressed and depending on the value set
in CONTROL SENSE TIME OUT .
In the case of control surface keys, writing ends
when the CONTROL SENSE TIME OUT
a key press. CONTROL SENSE TIME OUT

Figure 21: Writing new switch events over previous switch events with Auto Revert enabled

24
TASCAM DM Automation Guide
enabled, the automa-
has expired without
allows the con-
Existing Switch Events
1 sec
2 sec 3 sec 4 sec
Switch ON
Switch OFF
New Switch Events
1 sec
2 sec 3 sec 4 sec
Switch OFF
Resulting Switch Events
1 sec
2 sec 3 sec 4 sec
Switch ON
Switch OFF
trol surface keys to respond as if they are touch-sen-
sitive, even though they are not.
Writing switch events over a Static switch position
simply adds the new switch events. When writing
new switch events over previous ones, the TASCAM
DM automation system provides you with a high
degree of flexibility over when writing will end.
See the diagram below to understand this behavior:
5 sec 7 sec
6 sec 8 sec
Switch ON Switch ON
Switch OFF Switch OFF
5 sec 7 sec
6 sec 8 sec
Switch ON
Control
Sense
Timeout
7 sec
5 sec 6 sec 8 sec
Switch ON
Switch OFF
Control
Sense
Timeout