Write To End; Figure 23: Writing A New Switch Event With Write To End Enabled - Tascam DM-3200 Manual

4 – Operation : Writing Switch Events

Write To End:

When the Write Revert Time is set to ∞s, you are
essentially telling the automation system to maintain
that control's last setting from the point when auto-
mation recording ends, all the way to the end of the
program.
NOTE
A Write/Trim To End operation must be completed by
stopping the timecode. Manually disabling Write or
Trim mode while timecode is running will not perform a
Write To End operation.

Figure 23: Writing a new switch event with Write to End enabled

26
TASCAM DM Automation Guide
Existing Switch Events
1 sec
2 sec 3 sec 4 sec
Switch ON
Switch OFF
New Switch Events
1 sec
2 sec 3 sec 4 sec
Switch OFF
Resulting Switch Events
1 sec
2 sec 3 sec 4 sec
Switch ON
Switch OFF
AUTO REVERT must be enabled to use Write To End.
This is called Write To End. In this case, any switch
events existing in the time between the end of auto-
mation recording and the end of the program will be
erased.
See the diagram below to understand this Write to
End behavior:
7 sec
5 sec 6 sec 8 sec
Switch ON Switch ON
Switch OFF
7 sec
5 sec 6 sec 8 sec
7 sec
5 sec 6 sec 8 sec
Stop Time Code