Auto Config; Module; All Module; All Cntrls - Tascam DM-3200 Manual

3 – Automation overview : AUTO CONFIG
The other on-screen buttons, etc. work in the same
way as for other libraries, allowing deletion, protec-
tion, etc. of stored entries.

AUTO CONFIG

The grid represented in the
used for manual override of the automation's mode
switching. The selected channel is displayed in the
upper left of the display. If the displayed channel is
part of a group, this is indicated in the upper right of
the grid.
The changes made in this grid are applied to channel
and controls selected by the
right of the display. Use the rightmost POD encoder
to make this selection. Note that it is not necessary to
press ENTER to confirm this setting.
When a module or control is set to any mode except
Auto using this display, that module or control
remains in that mode until it is reset back to
The settings made in this display are saved as part of
the mix data.
NOTE
Image settings are part of the PAN control setting.

MODULE

When selected, the changes in this dis-
play will only be applied to the specified control on
the selected channel.
REVERT
The revert function provides a smooth transition
between the events being written and existing mix
moves.
Naturally, this only applies to continuous controls,
such as faders and pans (there is no smooth transition
14
TASCAM DM Automation Guide

Figure 8: AUTO CONFIG display

AUTO CONFIG display is
APPLY TO buttons at the
Auto .
DELETE permanently erases the contents of the high-
lighted mix file.
CAUTION
There is no undo for this operation.

ALL MODULE

When selected, the changes in this
display are applied to a single control across all chan-
nels. For example, with ALL MODULE
enabling SAFE in the FADER
into Safe mode.

ALL CNTRLS

When selected, the changes in this
display are applied to all controls on the selected
channel. This applies the changes to the libraries.

ALL

When selected, the changes in this display are
applied to all controls on all channels.

COPY

This soft key copies the configuration of the
currently-selected channel into a special clipboard
where it can then be pasted to another channel. A
popup message appears when this operation is car-
ried out.

PASTE

This soft key (only visible when a configu-
ration has been copied) pastes the configuration cop-
ied using the soft key to the currently-selected
COPY
channel. Note that there is no Undo for this opera-
tion.
that can be made between the on state and the off
state of a switch).
See "Revert Time " on page 16, "Auto Revert
Choices " on page 16, and also "Disabling Auto
Revert" on page 19.
selected,
row places all mixer faders