Auto Revert Choices - Tascam DM-24 Automation Manual

4 – Operation

Auto Revert Choices:

With —
AUTO REVERT WRITE/TRIM
mation system stops recording switch events auto-
matically on a per control basis, without any need to
end writing manually. In this case, keys stop record-
ing switch events at different times, depending on
when they were last pressed and depending on the
value set in CONTROL SENSE TIMEOUT
In the case of control surface keys, writing ends
when the
CONTROL SENSE TIMEOUT
out a key press. CONTROL SENSE TIMEOUT
+12
+6
+3
0
-3
-6
-12
+12
+6
+3
0
-3
-6
-9
-12
+12
+6
+3
0
-3
-6
-9
-12
Figure 17 – Writing new switch events over previous switch events with Auto Revert enabled.
24
TASCAM DM-24 Automation
enabled, the auto-
.
has expired with-
allows the
Existing Switch Events
1 sec 2 sec 3 sec
4 sec
Switch ON
Switch OFF
New Switch Events
1 sec 2 sec 3 sec
4 sec
Switch OFF
Resulting Switch Events
1 sec
2 sec 3 sec 4 sec
Switch ON
Switch OFF
control surface keys to respond as if they are
touch-sensitive, even though they are not.
Writing switch events over a Static switch position
simply adds the new switch events. When writing
new switch events over previous ones, the DM-24
automation system provides you with a high degree
of flexibility over when writing will end.
See the diagram below to understand this behavior:
5 sec 6 sec 7 sec 8 sec
Switch ON
Switch OFF
5 sec 6 sec 7 sec 8 sec
Switch ON
Control
Sense
Timeout
7 sec
5 sec 6 sec 8 sec
Control
Sense
Timeout