Wpa(2)-Psk - ZyXEL Communications P-660HW-Tx v3 Series User Manual

8.2.3 WPA(2)-PSK

Use this screen to configure and enable WPA(2)-PSK authentication. Click
Network > Wireless LAN to display the AP screen. Select WPA-PSK or WPA2-
PSK from the Security Mode list.
Figure 49 Network > Wireless LAN > AP: WPA(2)-PSK
The following table describes the wireless LAN security labels in this screen.
Table 32 Network > Wireless LAN > AP: WPA(2)-PSK
LABEL
Security Mode
WPA Compatible
Pre-Shared Key
ReAuthentication
Timer
P-660HW-Tx v3 Series User's Guide
DESCRIPTION
Choose WPA-PSK or WPA2-PSK from the drop-down list box.
This check box is available only when you select WPA2-PSK or WPA2
in the Security Mode field.
Select the check box to have both WPA-PSK and WPA wireless clients
be able to communicate with the ZyXEL Device even when the ZyXEL
Device is using WPA2-PSK or WPA2.
The encryption mechanisms used for WPA(2) and WPA(2)-PSK are
the same. The only difference between the two is that WPA(2)-PSK
uses a simple common password, instead of user-specific credentials.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters
(including spaces and symbols).
Specify how often wireless stations have to resend usernames and
passwords in order to stay connected. Enter a time interval between
10 and 9999 seconds. The default time interval is 1800 seconds (30
minutes).
Note: If wireless station authentication is done using a RADIUS
server, the reauthentication timer on the RADIUS server has
priority.
Chapter 8 Wireless LAN
143