ZyXEL Communications P-660HW-Tx v3 Series User Manual page 87

Table 10 Internet Access Wizard Setup: ISP Parameters
LABEL
Multiplexing
Virtual Circuit
ID
VPI
VCI
Back
Next
Exit
The next wizard screen varies depending on what mode and encapsulation type
2
you use. All screens shown are with routing mode. Configure the fields and click
Next to continue. See
setup
Figure 18 Internet Connection with PPPoE
P-660HW-Tx v3 Series User's Guide
DESCRIPTION
Select the multiplexing method used by your ISP from the Multiplex
drop-down list box either VC-based or LLC-based.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a
virtual circuit. Refer to the appendix for more information.
Enter the VPI assigned to you. This field may already be configured.
Enter the VCI assigned to you. This field may already be configured.
Click this to return to the previous screen without saving.
Click this to continue to the next wizard screen. The next wizard screen
you see depends on what protocol you chose above.
Click this to close the wizard screen without saving.
Section 5.3 on page 92
Chapter 5 Internet and Wireless Setup Wizard
for wireless connection wizard
87