Table of Contents
Advertisement
INFINITY ID2 USER MANUAL, MAINTENANCE GUIDE & LOG BOOK
Installation Certificate
Certificate of INSTALLATION for the Infinity ID2 Fire Alarm System installed at:
ADDRESS:
I/we being the competent person(s) responsible (as indicated by my/our signatures below) for the
installation of the fire alarm system, particulars of which are set out below, CERTIFY that the said
installation for which I/we have been responsible complies to the best of my/our knowledge and belief
with the specifications described below, and with the recommendations of BS5839-1:2002, except for the
variations, if any, stated in this certificate
Name (
):
Block Letters
Signature:
For & on behalf of:
Address
The extent of liability of the signatory is limited to the system described below.
Extent of the installation work covered by this certificate.
Specification against which the system was installed:
Variations from the specification and/or section 4 of BS 5839-1:2002 (see clause 7)
The wiring has been tested in accordance with the recommendations of clause 38 of BS 5839-1:2002. The
test results have been recorded and provided to:
Unless supplied by others, the "as fitted" drawings have been supplied to the person responsible for
commissioning the system (see BS 5839-1:2002 clause 36.2m)
Approved Document No: GLT2-211-7-2
Issue 1.00
Author: NRPJ
Date: 23/1/2013
Software Versions: PANEL 0.X – R8629 & LOOP 0.J-R624
Position:
Date:
PAGE 24
Advertisement
Table of Contents
