Kenmore 30" FREESTANDING ELECTRIC RANGE WITH DOUBLE OVENS Installation Instructions Manual page 3

Product Dimensions
C
A. 46%" (119.9 cm) C. 35%" (91.4 cm)
B. Model/serial number plate D. 29%" (75.9 cm)
(located behind the control E. 26%G" - 27'/4" (66.8- 69.2 cm)**
panel)*
*Serial number plate may be rotated up from behind the control
panel for viewing from the front of the range.
**Excludes handle. Dimension given is from wall to front of oven
door and will vary based on electric outlet receptacle
installation.
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
If installing a range hood or microwave hood combination above
the range, follow the range hood or microwave hood combination
installation instructions for dimensional clearances above the
cooktop surface.
A freestanding range may be installed next to combustible walls
with zero clearance.
G
F
H
A. !3" (33 cm) upper cabinet
depth
B. 30" (76.2 cm) min. opening
width
C. For minimum clearance to the
top of the cooktop,
see NOTE.
D. 30" (76.2 cm) min. opening
width
E. Cabinet door or hinge should
not extend into cutout.
F. 3-wire shaded area -
7" (17.8 cm) min. from left side
cabinet, 53/4" (14.6 cm) max.
from fleer, 6" (!5.2 cm) max.
width *
G. 4-wire shaded area -
!0" (25.4 cm) min. from right
side cabinet, 5_ '' (14.6 cm)
max. from floor, 6" (15.2 cm)
max. width*
H. !72" (3.8 cm) rain. from floor if
using a flush mount outlet.
Wothing located in shaded areas can extend more than 1_/2"(3.8 cm)
from wall or range will not slide all the wayback.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal
cabinet is protected by not less than 1/4"(0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bottom of an unprotected wood or metal
cabinet.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path and wire gauge are in accordance with local
codes.
Do not use an extension cord.
Be sure that the electrical connection and wire size are adequate
and in conformance with the National Electrical Code, ANSI/
NFPA 70-latest edition and all local codes and ordinances.
WARNING: Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check with a
qualified electrician or service technician if you are in doubt as to
whether the appliance is properly grounded. Do not modify the
power supply cord plug. If it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
A copy of the above code standards can be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269.