Complete Installation - Kenmore 30" FREESTANDING ELECTRIC RANGE WITH DOUBLE OVENS Installation Instructions Manual

30" (76cm) freestanding electric range with double ovens
Hide thumbs Also See for 30" FREESTANDING ELECTRIC RANGE WITH DOUBLE OVENS:
Table of Contents

Advertisement

Available languages

Available languages

Position c ord/conduit plate asshown i nthefollowing
illustration.
• Replace cord/conduit plate and insert s crews.
• Assemble a ULlisted conduit connector intheopening•
J
t
B
Electrical Connection
Options
If your home has:
And you will be
Go to Section:
connecting to:
4-wire receptacle
A UL listed,
4-wire connection:
(NEMA type 14-50R)
250-volt
Power supply cord
minimum,
40-amp, range
power supply
cord
4-wire direct
A fused
4-wire connection:
disconnect
or
Direct wire
circuit breaker
(12.7
ore)
box
3-wire receptacle
(NEMA type 10-50R)
A UL listed,
250-volt
minimum,
40-amp, range
power supply
cord
3-wire connection:
Power supply cord
3-wire direct
A fused
1"
disconnect
or
(2•5o_.\
circuit breaker
box
3-wire connection:
Direct wire
4-wire connection:
Power Supply Cord
Use this method for:
New branch-circuit
installations (1996 NEC)
Mobile homes
Recreational vehicles
In an area where local codes prohibit grounding through the
neutral
1. Part of metal ground strap must be cut out and removed.
5=
6.
A. Removable retaining nut
B. Strain relief
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block•
Tighten strain relief screw against the flexible conduit•
Replace back panel and screws on rear of range•
Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
A
B C
2=
A. Metal ground strap
B. Discard
C. Ground-link
screw
Use Phillips screwdriver to remove the ground-link
screw
from the back of the range• Save the ground-link
screw and
the end of the ground-link
under the screw•

Advertisement

Table of Contents
loading

Table of Contents