Table of Contents
Advertisement
6.1 Getting Started
<Figure 6.1.3>
With the "All Channels" icon highlighted <Figure 6.1.5> press the
the scan. Scanned channels will be shown on screen <Figure 6.1.6>
<Figure 6.1.5>
2) Manual Scanning
To manually scan a channel select the channel number using the
the remote control <Figure 6.1.7> and press
<Figure 6.1.7>
<Figure 6.1.4>
button to start
<Figure 6.1.6>
and
keys on
<Figure 6.1.8>
13
6.1 Getting Started
3) Channel Selection
You can use the
and
or
and
select desired channels.
If you know the channel number you can enter it using the NUMERIC buttons on the
remote control and wait 2 seconds for the change.
Detailed information about the selected channel will be displayed on the right hand
side of the screen <Figure 6.1.9>
<Figure 6.1.9>
You can use the following buttons to navigate between channels
and
: Moves one channel up or down
-
and
: Moves one page up or down
-
- RED : Shows all channels in the current group
- Green : Shows all channels alphabetically
- Yellow : Shows all channels by transponder
- Blue : Shows all channels by CAS.
Press
when the selection bar is positioned on the desired channel.
keys to navigate between channels to
14
Advertisement
Table of Contents
