Tubular Stainless Steel Handles - Monogram ZIR36N LH Installation Instructions Manual

ZKHRSS1 Trim Kit (For 1/4" Panels)
Tubular Stainless Steel Handles
Step 2
Match
handle
extrusions
to handle
See Step 2A
for Stainless
Steel panels
• Cut a piece of corrugated to use as a pad to
protect the panel finish. Use 1/2" thick section
of plywood to protect flooring when drilling.
• Place custom panel on the pad, appearance side
down.
• On the back side of the panel-at the handle side,
measure and mark 1/4" below the top edge of the
panel with a pencil.
• Slip panel into new extrusion on the handle side of
the panel.
• Align the extrusion at the pencil mark, 1/4" below
the top of the panel.
• Tape the extrusion to the panel to prevent
movement.
• Center punch and drill 1/8" pilot holes through the
holes in the extrusion and into the panel.
• Turn panel oven On the appearance side, use 9/32"
bit to enlarge clearance hole.
IMPORTANT: Hole locations must be exact to accept
handle standoff and handle assembly.
Custom
Door_ /
Panel
_j_Extrusi0n
I
I
Step 2A
If gou are installing handle onto a Stainless Steel
Panel:
Use extreme caution if gou ore drilling through o
stainless steel panel. Stainless steel panels must be
handled gentlg. Do not kneel on the stainless steel
panel. It will leave a permanent dent. Do not remove
protective plastic covering until final installation.
• Place supplied filler panel (corrugated) on floor to
use as a pad.
• On the back side of the panel-at the handle side,
measure and mark 1/4" below the top edge of the
panel.
• Slip panel into the new extrusion, flush against
inner edge, on the handle side.
• Align extrusion to pencil mark as shown in Step 2.
Mark each screw hole location with pencil.
• Tape extrusion to panel to prevent movement.
• Place panel on plgwood section, appearance side
down. Be sure plgwood is clean without nicks and
burrs. Center punch at each screw hole location.
• Drill 1/8" pilot hole. Use 9/32" bit to enlarge
clearance hole.
• Measure and cut a 2" wide strip, top to bottom
off the corrugated panel. This will allow room for
spacer rings between the stainless panel and
extrusion.
30