Cabinets; Panel Kits - Monogram ZIR36N LH Installation Instructions Manual

Design Information
36" Refrigerators, Freezers
Installation
Between
Base and
Wall Cabinets
Installation
At End-of-Run
Frameless
Cabinets
Accessory
Panel Kits
Advance
planning
exterior
appearance
options
Refrigerator or Freezer
R°ugh-ln Finished Dim[lDim. _ I_1
NOTE: 1/4" thick side
panels can
be inserted
into the case trirn, making the rough-in the
same as the outside trim width, 36".
P
Cabi,n
Refrigerator or Freezer
Refrigerator and Freezer
installed side-bg-side
Cab
NOTE: 1/2" thick side panels
shown. Side panels can be ang
thickness. Add side panel thickness
to outside trim width, (36" or 72"
for two models} to calculate the
rough-in dimension. The leading
(front} edge must be finished to
rnatch surrounding cabinetry.
Side panels, 1/2" minimum thickness are required
when using frameless cabinets. The side panel acts
as a spacer between the cabinet and the case trim
and prevents interference with cabinet door swing.
The leading (front) edge must be finished to match
surrounding cabinetrg. _.
1/2" To 3/4" Side Panels. Leading _
Edge Flush With Cabinet
R ir era
Cabinet k
Refrigerator door \
These refrigerators and fi-eezers require field installed
door and grille panels. The factorg installed trim will
accept accessorg panel kits. Black Lexan ® and
stainless steel kits are available. Panels are cut
to size and readg to install Panel kits must be
ordered separatelg.
ZWBR36, Black Lexan ® Panels
ZWSR36, Stainless Steel Panels
These refrigerators and freezers are designed to be
customized with decorator door and grille panels.
Field installed custom door- and grille panels are
required.
Door and grille panel sizes varg to accommodate the
kit being used. Sizes are provided in this booklet
CAUTION: Maximum door panel weight is 50 pounds.
Side panels must be used whenever- the sides of the
refrigerator will be exposed. Side panel sizes varg
depending on the installation.
3/4" thick custom panels--Without trim kits
A raised panel design, screwed or glued to a 1/4"
thick backing can be used. See page 8.
You should:
1. Select the appearance option.
2. Order the trim kit for that option.
3. Order the custom door and grille panels from the
cabinet manufacturer. The exact dimension for
each trim kit application is provided in this booklet.
Find and pull out the page for gour application and
fax or send it to the cabinet manufacturen
4. Determine the final installation situation and order
matching side panels. 5