Support For Custom Handles - Monogram ZIR36N LH Installation Instructions Manual

ZKHR1 Trim Kit (For 1/4" Panels)
Support for Custom Handles
Step 2
Locate
handle
position
i .°
Slide custom panel into the door trim.
Temporaril U secure the new handle extrusion to the
door using at least 2 screws.
The custom handles must be located 3/4" to 1-1/2"
from the edge of the extrusion.
3/4" Min.
1-1/2" Max.
Determine the desired location of the custom
handle and mark centerlines of the screw holes.
Drill 1/16" pilot hole through the panel until it starts
into the aluminum extrusion. This will mark the
matching location for drilling the clearance hole
when assembling the handle, panel and extrusion.
Step ._
Assemble
panel
extrusion
and handle
Dec0rat0r_ /
DoorPanel
_Extrusi0n
Handle_ .....
3/a," IVlln.
" Max.
Decorator
Door _.-/
Panel
Screw
Remove the handle extrusion end custom panel.
Drill 1/16" pilot hole through extrusion.
Drill clearance holes through the panel and
extrusion.
Assemble the door panel, extrusion and custom
handle.
Install screw(s)long enough to pass through the
extrusion, door panel and into the handle.
Slide the assembl U into the door frame until the
new extrusion fits firml U against the steel doon
Reinstall original screws into the door extrusion.
21