Display; Sequence - EverFocus ECOR960 X1 User Manual

4.4 Display

You can display system and camera status on the live view screen. Follow the steps below:
1. Right-click to display the OSD Root Menu or press the Display button on the front panel to
display the system and camera status.
2. The following icons will be displayed at the top-left side of each camera stream to show each
camera's status.
Recording
Alarm
3. The following icons will be displayed at the bottom of the monitor to show the system
status..
Alarm
Motion
4. There are four display modes, and you can click the Display icon or press the Display button
on the front panel to change the display mode: (1) Display the camera and system status
icons. (2) Display only the camera status icons. (2) Display only the system status icons. (4)
Hide both the camera and system status icons.

4.5 Sequence

The sequence function is used to display each channel in sequence and for the configured
amount of time. The default setting is channels 1~16 with a dwell time of 3 seconds each –
repeated. Please refer to 6.8.2 Main M/T SEQ and 6.8.3 Call M/T SEQ for detailed information.
To enable this function:
By Mouse: Click the Sequence button
By Front Panel: Press the "SEQ" button on the front panel to enter the sequential switching
mode.
Playback Fast forward
Motion Video loss
Audio Event
Video loss No network
Fast backward
Express copy
HDD failure
Seq.
to enter the sequential switching mode.
40
ECOR960 X1
Back pause
Audio out
HD temp. too high