5. Ensure that the Drobo device is not actively transferring data (blinking yellow and green), and
then click the OK button.
A dialog box opens, asking you to locate the zip file on your computer.
6. Please do so and then click the Open or OK button.
Drobo installs the firmware. When finished, a message opens, asking you to reboot your
Drobo device to complete the installation.
7. Click the Yes button.
Drobo shuts down and restarts after the new firmware is installed.
Safely Shutting Down Your Drobo 5N
If you plan to shut down your Drobo 5N for any reason, it is very important that you always do so
safely. Improper Drobo device shutdowns may cause file corruption and/or data loss.
It is a good idea to shut down your Drobo device before any of the following situations:
•
You are not going to be using your Drobo device for an extended period
•
You are going to disconnect the cable(s) or power cord
•
You want to move your Drobo to another location
•
You are going to remove the entire disk pack
•
You are going to apply operating system updates
This section covers the following topics:
Safely Shutting Down Your Drobo 5N Using Drobo Dashboard
Safely Shutting Down Your Drobo 5N Manually
Drobo 5N Getting Started Guide
22