Attaching A Pc Or Terminal - Brocade Communications Systems ICX 6650 Installation Manual

FIGURE 12
3. Position the switch in the cabinet, providing temporary support under the switch until the rail
4. Attach the front right bracket to the rail rack using two 10-32 x 5/8 in. screws and the
5. Repeat
6. Attach the rear right bracket to the rail rack using two 10-32 x 5/8 in. screws and the
7.
8. Proceed to

Attaching a PC or terminal

To assign an IP address, you must have access to the Command Line Interface (CLI). The CLI is a
text-based interface that can be accessed through a direct serial connection to the device and
through Telnet connections. The CLI is described in detail in the Brocade ICX 6650 Administration
Guide.
Access the CLI by connecting to the console port. After you assign an IP address, you can access
the system through Telnet, or Brocade Network Advisor.
Use the following steps to attach a management station to the console port:
1. Connect a PC or terminal to the console management port on the back of the ICX 6650 device
Brocade ICX 6650 Hardware Installation Guide
53-1002599-02
Optional 4-post Rack Mount Kit, Side Attach
kit is secured to the cabinet.
appropriate round or square retainer nuts.
step 3 to attach the left front bracket to the left front rack rail and tighten all 10-32 x
5/8 in. screws to a torque of 25 in-lb (29 cm-kg). See
appropriate round or square retainer nuts.
Repeat step 6 to attach the left front bracket to the left front rack rail and tighten all 10-32 x
5/8 in. screws to a torque of 25 in-lb (29 cm-kg).

"Attaching a PC or terminal"

using the mini-USB serial console port cable (Part number 50-1000059-01.
For port pinout information for the mini-USB serial console port, see the section
signalling" on page 74.
Attaching a PC or terminal
Figure 9.
on page 33.
2
"Pinouts and
33