Mounting; Orientation; Rigging - Chauvet MiN Spot RGBW User Manual

Mounting

Orientation

The MiNSpot™ RGBW may be mounted in a hanging or sitting position. There must be adequate
room for ventilation. The structure to which the fixture is mounted must be a level surface, at 180°.
This instruction must be followed in order to prevent damage to the fixture.
Do not mount the fixture sideways!

Rigging

Be sure that the structure can support the weight of the fixture. Please see the "Technical
Specifications" section of this manual for a detailed weight listing. When rigging, consider routine
maintenance and control panel access. Please see the following steps for installation.
1. There are (2) screws that are used to attach the hanging bracket to the base of the fixture. Use a
5 mm Allen wrench to install. These should be hand-tightened and installed at the bracket
attachment points (2).
2. Install the safety attachment bolt to the base of the fixture, in the location shown below. This
should be hand-tightened.
3. Mount the fixture securely. This may be done with a screw, nut and bolt, or a hanging/rigging
clamp. The hole in each bracket is 13 mm in diameter.
•
•
•
Bracket attachment
points
Safety
attachment
3. Setup
There are 2 different methods of mounting this fixture. There is a single bracket which may
be used for hanging the fixture. There are also 4 rubber feet, which are used for floor
standing purposes (uplighting). The hanging/mounting bracket should NOT be used for
floor standing operation.
Safety cables must always be used.
2 clamps, one on either end of the bracket, may be used if using two mounting positions,
such as two (2) clamps.
point
Base of Fixture
Hanging/Mounting
Bracket
8
Microphone
Double, outer
mounting
locations (2)
6/14/2010 4:13 PM