Garmin 300XL Pilot's Manual And Reference page 74

DIRECT-TO
SECTION
5
Manually Selecting
A Course
The waypoint sequencing field, located at the
bottom left of the direct-to confirmation page, dis-
plays the current status of the external GPS SEQ
switch.
To manually set your course from the course select
field, set the GPS SEQ switch to the 'AUTO' posi-
tion and enter the selected course in the course
select field. NOTE: Whenever the GPS SEQ switch
is set to the 'HOLD' position, the selected course
will be determined by the external OBS/HSI.
When using the course select feature on the direct-
to confirmation page or when the GPS SEQ switch
is set to the 'HOLD' position and external course
input is not present, you may also enter the
desired course from the CDI page using the course
field at the bottom of the page.
64
Whenever you perform a direct-to, the GNC 300XL will set a point-to-point great
circle course to your destination. You can also manually define the course to your
destination with the GNC 300XL' s course select feature. The course select feature is
available from the bottom line of the direct-to confirmation page and works like
selecting an OBS course on a VOR indicator.
Waypoint Position, Facility
Name or City/Region
(selectable)
Waypoint
Sequencing Field
To manually set a course:
1. Set/confirm the GPS SEQ switch in the 'AUTO' position.
D
2. Press the key. The direct-to confirmation page will appear.
O
3. Rotate to place the cursor on the course select field.
K
4. Use to begin entry of the selected course (the
you have started editing the course select field).
E
5. Press to accept the course, and
The GNC 300XL will now use the selected course for your CDI and DTK steering
guidance. To reset the course to a GPS-calculated course from your present position,
simply press D, followed by E.
Waypoint Identifier Field
Course Select Field
O K
and knobs may be used once
E
again to acknowledge the 'ok?' prompt.