Table of Contents
Advertisement
1.
Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2.
Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
3.
For better Clock Display clarity, avoid operating the unit under direct sunlight or in strong room
illumination.
4.
Unplug the unit from the electrical power outlet immediately in case of malfunction.
CLEANING THE UNIT
To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use
caution when cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or
polishes as these will damage the finish of your unit.
:
CAUTION
Never allow any water or other liquids to get inside the unit while cleaning.
Symptom
The unit does not
respond (no power).
iPad/iPod/iPhone
does not respond to
the speaker system.
iPad/iPod/iPhone
does not charge.
Remote control
No functions or short
range.
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
Possible Problem
AC Adaptor is not plugged
into a wall outlet or the
connector is not plugged
into the power supply jack
on the back of the unit.
Wall
outlet
is
functioning.
iPad/iPod/iPhone is not
installed properly.
Your iPad/iPod/iPhone is
locked up.
Unit not in
iPad/iPod/iPhone mode
iPad/iPod/iPhone is not
installed properly.
iPad/iPod/iPhone is locked
up/ frozen.
iPad/iPod/iPhone battery
has problem.
Battery exhausted
Plug the AC adaptor into a wall outlet and plug
the connector into the supply jack on the unit.
not
Plug another device into the same outlet to
confirm the outlet is working.
Remove your iPad/iPod/iPhone from the dock
and check for obstruction on the connectors in
the dock and on your iPad/iPod/iPhone. Then
reseat it on the dock.
Please make sure that your iPad/iPod/iPhone
is working properly before docking into the
unit. Please refer to your iPad/iPod/iPhone
manual
for
info
iPad/iPod/iPhone.
Make
sure
the
iPad/iPod/iPhone mode.
Remove your iPad/iPod/iPhone from the dock
and check for obstruction on the connectors in
the dock and on your iPad/iPod/iPhone. Then
reseat it in the dock.
Please make sure your iPad/iPod/iPhone is
working properly before docking into the unit.
Please refer to your iPad/iPod/iPhone manual
for details on resetting.
- Insert new batteries.
- Aim remote directly towards the remote
sensor.
13
Solution
on
resetting
function
is
set
the
to
Advertisement
Table of Contents
