Care And Maintenance; Cleaning The Unit; Troubleshooting Guide - Jensen JiTS-300i User Manual

Docking digital music system for ipod and iphone
Table of Contents

Advertisement

1. Do not subject the unit to excessive force, shock, dust or extreme temperature.
2. Do not tamper the internal components of the unit.
3. Clean your unit with a dry cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.

CLEANING THE UNIT

To prevent fire or shock hazard, disconnect your unit from the AC power source
when cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other
furniture, Use caution when cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax
or polish sprays on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with
a soft cloth slightly dampened with a mild soap and water solution. Never use
abrasive cloths or polishes, as these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
Should you experience difficulties in the use of this player please refer to the following chart or
call 1300 366 144 for Product Service and Support.
Symptom
The unit does not
respond (no power)
Unit is ON but there
is low or no volume
iPod / iPhone does
not dock properly
iPod / iPhone does
not respond to the
speaker system

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

Possible Problem
The unit is disconnected from
the AC outlet.
The AC outlet has not power.
The volume control has been
turned all the way down.
Using no/wrong iPod / iPhone
bracket.
iPod / iPhone not installed
properly.
iPod / iPhone is not installed
properly.
Reconnect to the AC outlet.
Try the unit on another outlet.
Turn the Volume control to a higher
output.
Make sure the dock insert is the
proper fit for your iPod / iPhone.
Remove your iPod / iPhone from the
dock and check for obstruction on
the connectors in the dock and on
your iPod / iPhone. Then carefully
reseat it in the dock.
Remove your iPod / iPhone from the
dock and check for obstruction on
the connectors in the dock and on
your iPod / iPhone. Then carefully
reseat it on the dock.
11
Solution

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents