Troubleshooting Guide; Specifications; Service - Jensen JiMS 220 - Docking Digital Music System Owner's Manual

TROUBLESHOOTING GUIDE

Symptom Possible Problem
AC Adaptor is not plugged into a
wall outlet or the connector is not
plugged into the power supply jack
The unit does
on the back of the unit.
not respond (no power)
Wall outlet is not functioning.
Using no/wrong iPod Adaptor.
iPod does not
iPod does not install properly.
dock properly
iPod is not installed properly.
iPod does not respond
Your iPod is locked up.
to the speaker system
Unit turned to CD or radio mode
iPod is not installed properly.
iPod does not
charge up
iPod is locked up/ frozen.
iPod battery has problem.
The reception at the set location is
AM band is too noisy
poor.
Volume level is set too high.
Sound is distorted
Sound source is distorted.
CD Player does not play. CD mode is not selected.
CD is not installed or installed
incorrectly
CD skips while playing. Disc is dirty or scratched.
This is normal.
Unit gets warm after
extended play at
high volume
17
Power Requirement
Solution
Main unit
Plug the AC adaptor into a wall
DC input:
outlet and plug the connector into
Battery Back-up for Clock
the supply jack on the unit.
Plug another device into the same
Remote Control
outlet to confirm the outlet is working.
Make sure the dock insert is the
proper fit for your iPod.
Frequency Range
Remove your iPod from the dock
Radio
and check for obstruction on the
connectors in the dock and on your
iPod. Then reseat it in the dock.
Remove your iPod from the dock
and check for obstruction on the
connectors in the dock and on your
iPod. Then reseat it on the dock.
Please make sure that your iPod is
working properly before docking into
the unit. Please refer to your iPod
manual for info on resetting the iPod.
Select other modes for iPod charging
Remove your iPod from the dock
and check for obstruction on the
connectors in the dock and on your
iPod. Then reseat it in the dock.
Please make sure your iPod is
working properly before docking into
the unit. Please refer to your iPod Please refer to the instructions on the enclosed warranty card for returning your unit for service. When
details on resetting. returning the unit, please remove batteries to prevent damage to the unit in transit and/or from possible
manual for
leakage. We are not responsible for batteries returned with the product or for the cost of replacement.
Slightly rotate the unit for the best
reception.
Decrease the volume. Distributed in Australia by:
ROVEREY INTERNATIONAL
If the iPod original sound source is of
PO Box 3414
poor quality, distortion and noise are
Nunawading
easily noticed with high-power
Vic 3110
speakers. Try a different audio source
Telephone: 1800 686 079
such as a music CD.
Email Address: warranty@roverey.com.au
If you are using an external sound
source like older generation of iPod,
*The specification and external appearance of the set are subject to change without prior notice.*
try reducing the output volume on the
device itself. Also try turning bass
boost OFF or change the EQ setting.
Slide the FUNCTION switch to select
CD mode.
Press the CD onto spindle, printed
side facing up.
Wipe with cloth or use another disc.
Turn the unit off for a period of time or
lower volume.

SPECIFICATIONS

DC10V / 1000mA
2 X DC 1.5V "AAA" (UM-4) Batteries
1 x CR2032 Lithium Battery
AM 522 ---- 1620 kHz, 9 kHz tuning step
Fm 87.5 ---- 108 MHz, 0.05 MHz tuning step

SERVICE

Printed in China
18