Table of Contents
Advertisement
CARE AND MAINTENANCE
, Do not subject the unit to excessive force, shock, dust or extreme temperature.
, Do not tamper the internal components of the unit.
, Clean the unit with a damp (never wet) cloth except metal contact or speaker grille. Solvent or
detergent should never be used.
, Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
, Keep your unit away from heating appliances and sources of electrical noise such as fluorescent
lamps or motors.
, Always keep your find dry and clean before touching all the buttons.
TROUBLESHOOTING GUIDE
SYMPTOM
POSSIBLE PROBLEM
A C - D C a d a p t o r i s n o t
plugged into a wall outlet
or the connector is not
plugged into the DC jack
on the back of the unit.
This unit does not
r e s p o n d
( N o
W a l l
power)
functioning.
Using no / wrong iPod
adaptor.
i P o d d o e s n o t i n s t a l l
properly.
i P o d d o e s n o t
r e s p o n d t o t h e
unit.
Your iPod is locked up.
iPod does not installed
properly.
i P o d d o e s n o t
charge up.
Problem with the iPod
battery.
E x t e r n a l s o u r c e
3.5mm headphone cable
( A U X )
i s
n o t
is not connected properly.
responding.
Volume is set too high.
S o u n d
i s
distorted.
Sound source is distorted.
R
a
d
i
o
Too close to a radio tower.
interference.
Plug the AC adaptor into a wall outlet and plug the connector
into the supply jack on the unit.
o u t l e t
i s n o t
Plug another device into the same outlet to confirm
the outlet is working.
Make sure the dock adaptor is the proper fit for your iPod.
Remove your iPod from the dock and check for any
obstruction on the connector in the dock and on your
iPod. Then reseat it on the dock.
Please make sure that your iPod is working properly
before docking into the unit. Please refer to your iPod
manual for details or use the remote control..
Remove your iPod from the dock and check for any
obstruction on the connector in the dock and on your
iPod. Then reseat it on the dock.
Please make sure that your iPod is working properly
before docking into the unit. Please refer to your iPod
manual for details.
Check the connection and make sure the cable is
inserted firmly into those jacks.
Decrease the volume of the unit to fit your preference.
If you are using an external sound source like older
generation of iPod, try reducing the output volume on
the device itself. Also, try tuning bass boot OFF or
change EQ setting.
Move your speakers to see if the interference goes
away. You may be able to purchase a shielded cable at
your local electronics store.
7
SOLUTION
Advertisement
Table of Contents
