Download  Print this page

Removing Accumulated Lint; Vacation And Moving Care; Troubleshooting - Kenmore 110.C8756 Series Use & Care Manual

Hide thumbs

Advertisement

Table of Contents

Removing Accumulated Lint

From Inside the Dryer Cabinet
Lint should be removed every 2 years, or more often, depending
on dryer usage. Cleaning should be done by a qualified person.
From the Exhaust Vent
Lint should be removed every 2 years, or more often, depending
on dryer usage.

Vacation and Moving Care

Vacation care
Operate your dryer only when you are at home. If you will be on
vacation or not using your dryer for an extended period of time,
you should:
1. Unplug dryer or disconnect power.
2. Clean lint screen. See "Cleaning the Lint Screen."
First try the solutions suggested here and possibly avoid the cost of a service call...
Dryer will not run
I
Has a household fuse blown, or has a circuit breaker
tripped?
There may be 2 fuses or circuit breakers for the dryer. Check
to make sure both fuses are intact and tight, or that both
circuit breakers have not tripped. Replace the fuse or reset
the circuit breaker. If the problem continues, call an
electrician.
I
Is the correct power supply available?
Electric dryers require 240 volt power supply. Check with a
qualified electrician.
I
Was a regular fuse used?
Use a time-delay fuse.
I
Is the dryer door firmly closed?
I
Was the Power button pressed?
I
Was the Start button firmly pressed?
Press and hold for 1 second.
No heat
I
Has a household fuse blown, or has a circuit breaker
tripped?
The drum may be turning, but you may not have heat. Electric
dryers use 2 fuses or circuit breakers. Replace the fuse or
reset the circuit breaker. If the problem continues, call an
electrician.
20
1. Unplug the power supply cord.
2. Make sure leveling legs are secure in dryer base.
3. Use masking tape to secure dryer door.

TROUBLESHOOTING

Dryer Operation
I
I
I
I
I
I
Moving care
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Unusual sounds
Has the dryer had a period of non-use?
If the dryer hasn't been used for a while, there may be a
thumping sound during the first few minutes of operation.
Is a coin, button, or paper clip caught between the drum
and front or rear of the dryer?
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
Are the four legs installed, and is the dryer level front to
back and side to side?
The dryer may vibrate if not properly installed. See
"Installation Instructions."
Is the clothing knotted or balled up?
When balled up, the load will bounce, causing the dryer to
vibrate. Separate the load items and restart the dryer.
Dryer displaying code message
"PF" (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press POWER, and then press and hold START to restart the
dryer.
"E" Variable (E1, E2, E3) service codes:
Call for service.

Advertisement

Table of Contents
loading

  Also See for Kenmore 110.C8756 Series

This manual is also suitable for:

110.c8758 series110.c8757 series