Ending A Call; Using Hold And Resume - Cisco 7975G Software Manual

Ending a Call

To end a call, simply hang up. Here are some more details.
If you want to...
Hang up while using the handset
Hang up while using a headset
Hang up while using the speakerphone Press
Hang up one call, but preserve another
call on the same line

Using Hold and Resume

You can hold and resume calls. When you put a call on hold, the Hold icon
in the call information area and the corresponding line button flashes green
the line button flashes green when you place a call on hold, and the phone displays the hold icon. When
another phone places a call on hold, the line button flashes red, and the phone displays the remote
hold icon.
If the Hold Reversion feature is enabled for your phone, a call that you put on hold reverts to ringing
after a certain time. The "reverting" call remains on hold until you resume it or until Hold Reversion
times out. Your phone indicates the presence of a reverting call by the following:
• Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).
• Briefly displaying a "Hold Reversion" message in the status bar at the bottom of the phone screen.
• Displaying the animated Hold Reversion icon
• Displaying a flashing amber line button
If you want to...
Put a call on hold
Remove a call from
hold on the current line
6
Then...
Return the handset to its cradle. Or press EndCall.
Press
Cisco Unified IP Phone 7975G, 7965G, and 7945G support
a wireless headset. If you are using a wireless headset, refer
to the wireless headset documentation for instructions.
Press EndCall. If necessary, remove the call from hold first.
Then...
1. Make sure that the appropriate call is highlighted.
2. Press Hold.
1. Make sure the appropriate call is highlighted.
2. Press Resume.
. Or, to keep headset mode active, press EndCall.
or EndCall.
next to the caller ID for the held call.
(depending on the line state).
appears on the right
. With a shared line,
OL-22332-01