Fault Diagnostics; Vi. Fault Diagnostics; Via. Customer Service Test Program - Kenmore 630.13952 Manual

Fault Diagnostics

VI. Fault Diagnostics

VIA. Customer service test program

Entering customer service test program
Controls contain codes for factory tests, customer service test program,
dishwasher configuration and error codes. Consult test programs and error
codes for your dishwasher before using the codes from this manual.
1. Open the door.
2. While pushing (and holding) any two wash cycle buttons, turn the
dishwasher on with the on/off switch. While the buttons are held, the
model coding will show (e.g. "C2", "C5", etc.).
buttons, LED "B" will be lit, LED "C" will flash and "P0" will display,
confirming you're in the special programs menu.
3. To select the test program, push button "B" repeatedly until "P1" is
displayed or until LED "C" is lit.
4. Push button "C" to start the program -- LED "C" will blink. Close the door
after pushing button "C"). The steps will show on the digital display (e.g.-
"S:01") -- push button "B" to skip a step.
Stored error codes will show on the digital display and LED's (see Error code
displays on the next page).
The test program can only be stopped / reset by pushing the on/off button – it
can't be done by turning off the power.
702_58300000149896_ara_en_b
After releasing the