Iiic. Entering Special Programs And Coding - Kenmore 630.13952 Manual

OPERATION
Changing basic features
Some features can be changed on the fascia panel.
End of cycle tone
The End of cycle tone volume can be changed.
Turn the dishwasher off and then push and hold the right Cancel Reset button
while turning the dishwasher on – release buttons when a tone sounds or the
right Cancel Reset button LED lights up.
Pushing the right Cancel Reset button changes the setting – push it until the
tone is at the desired volume (or the tone stops if it's to be turned off). Push the
on/off button to save the setting.
IIIC. Entering special programs and coding
Controls contain codes for sales demo mode, factory tests, customer service
test program, dishwasher configuration and error codes.
While pushing (and holding) any two wash cycle buttons, turn the dishwasher
on with the on/off switch. The current coding (e.g. "C2") will show in the display
or LED's until you release the buttons. After releasing the buttons, LED "B" will
be lit and LED "C" will flash, confirming you're in the special programs menu.
Push button "B" repeatedly until you've selected your desired program (see
P(X) Program codes, "P1" or "P4" -- programs "P0" and "P3" are factory tests
that aren't to be used).
702_58300000149896_ara_en_b