Kenmore 630.13952 Manual page 30

Repair
Heater
To raise (block up) right side of tank
Tools needed: T20 Torx screwdriver and pliers.
1. Remove one T-20 Torx screw from both rear corners holding tank to base
(1) -- removing screw from both sides allows tank to be blocked upward.
2. Remove T-20 Torx screws from front right bottom corner holding tank to
base (2).
3. Remove right hinge cover (3) and release right door tension cord from
hinge (4).
4. Raise and block up tank as shown with strut onto base (5a), sliding a piece
of wood or other solid material between the tank and base to keep tank
from falling back onto base (5b).
702_58300000149896_ara_en_b
Sump Access to circulation pump,
heater and sump after base
has been removed.
Pump