Cisco Wireless Service Module 2 Getting Started Manual page 47

Chapter 2 Setting Up and Configuring the Multi Services Platform
To configure NTP, follow these steps:
Procedure
Access the YaST Control Center window as described in the
Step 1
System and Accessing the YaST Control Center" section on page
In the left panel of the YaST Control Center window, click Network Services,
Step 2
then click NTP Configuration in the right panel, as shown in
Figure 2-16
The Advanced NTP Configuration area appears, as shown in
Step 3
OL-19733-01
Performing the Initial Configuration of the Multi Services Platform
Accessing NTP Options
Cisco Video Surveillance Manager Getting Started Guide, Release 4.2/6.2
"Powering On the
2-12.
Figure 2-16.
Figure 2-17.
2-25