Adding Analog Cameras - Cisco Wireless Service Module 2 Getting Started Manual

Chapter 3 Configuring VSM
Step 7
Step 8

Adding Analog Cameras

OL-19733-01
Figure 3-22 New Password Field
In the Confirm Password field (see
c.
Figure 3-23 Confirm Password Field
Click the Submit button to add the encoder.
Repeat Step 4 through
Adding analog cameras is the process of configuring information about the analog
cameras that will operate in your VSM deployment. This information includes the
name of each camera and information about its video stream.
Before you can add analog cameras, you must configure video encoders as
described in the "Adding Video Encoders" section on page
use analog cameras, skip this section.
Cisco Video Surveillance Manager Getting Started Guide, Release 4.2/6.2
Figure
Step 7 as needed to add other video encoders.
Configuring VSM
3-23), reenter the password.
3-11. If you will not
3-17