JVC DT-V9L5 Instructions Manual page 36

Configure the settings for the wave form monitor and vector scope.
Item To do
Gain* 2 Adjust the input gain level.
Size* 3 Set the window size.
Position Select the window position.
Transparent Activates/deactivates the function to make the window translucent.
Auto Off Set the function to turn off the window automatically 15 minutes after displayed.
Histogram Display Select the signal component for the histogram display.
Wave Display Select a wave form to be displayed for the wave form monitor.
Wave Filter Turn on/off the lowpass filter to put over the input wave form data.
Wave Over Level Marking Turn on/off the function to change the wave form color of signals over the value specified in
"Wave Over Level". (☞ below)
Wave Over Level Adjust the lower limit for the over level.
<Example of the histogram display>
< dark brightness
The start and the end of the gradient
correspond to 0% and 100% of the signal.
(DT-F9L5 only)
* 1 The vector scope is not displayed when the input signals are RGB.
* 2 Unavailable for the histogram.
* Only "Normal" is available for the histogram. (DT-V9L5 only)
3
* 4 DT-F9L5 only.
Settings for the synchronization with signals.
Item To do
No Sync Action Select the screen status when no signal is coming in.
Delay Time Select the period until the screen status changes as selected in "No Sync Action" after signals
stop coming in.
Low Latency Activates/deactivates the function to shorten the time taken to display the picture (low
latency function).
●
When setting "No Sync Action" to "Gray Back," the screen color changes to gray and the power consumption of the backlight is saved by half.
Selecting "Power Save" (power save mode) saves more power consumption by turning off the backlight.
36 36
Off : Normal
On Translucent
:
<Example of the wave form monitor>
Red
Y
Start
light >
Ex.: When the luminance signal is Y, "Wave Over
Level Marking" is set to "On" and "Wave Over
Level" is set to "80"
• The wave form color of signals over the value
specified in "Wave Over Level" turns red.
• The display differs depending on the input
signal or the "Wave Display" setting.
If the picture is not displayed steadily while "On" is selected, select "Off."
While "On" is selected, the displayed picture may become unstable when an operation
using buttons on the front panel or the menu is performed, or when the signal format
changes.
White
Image signals
End
Setting value
–10 to +10
Normal, Large
Lower Right, Lower Left
Upper Left, Upper Right
Off
On
Off, On
Y, R, G, B, RGB* 4
Y, Pb, Pr (HD signal)
Y, Cb, Cr (SD signal)
R, G, B (RGB signal)
Flat (No filter)
Lowpass
Off, On
70 – 109
<Example of the vector scope>
Ex.: When the color bar is displayed
Setting value
Off, Standby, Power Save
(power save mode)
Gray Back (gray screen)
30s, 5min, 15min
Off, On
,