JVC DT-V9L5 Instructions Manual page 31

When you turn on the power and the monitor, "First Time Installation" appears.
Start setting referring to the menu configuration.
For the setting items, see the pages below.
☞ "Language" on page 39
• "Language"
☞ "Sync Function" on page 36
• "No Sync Action"
☞ "No Operation Action" on page 37
• "No Operation Action"
Press to move the cursor to the setting item
Press to select the setting values
●
Each time you press one of these buttons, the setting value changes.
Move the cursor to "Set"
Press to finish setting
●
When you change the settings, a confirmation message appears.
Operate according to directions.
Press the MENU button to display the Main Menu
➡ Press the MENU button.
➡ Press the
button while holding the
Use the buttons to select an item and press the
proceed to the next screen
●
For some items, pressing the
Use the buttons to select an item and use the
to adjust the setting
Press the MENU button to finish operations
●
Press the MENU button repeatedly until the menu screen disappears.
button.
button to
buttons adjusts the setting.
buttons
●
Once the settings have been adjusted, this screen will not appear
again.
●
The settings can be changed afterwards in Main Menu and Set-Up
Menu.
The illustrations of the menu screens are from DT-V9L5.
Main Menu
Selected item
Operation guide
●
The menu screen disappears automatically if no operations are
made for about 30 seconds.
●
Inoperable menus will be grayed out.
●
Some items will not be displayed on the menu depending on the
selected input and signal format.
Set-Up Menu
Ex.: When "Picture Function"
in the Main Menu is selected
31 31