JVC DT-V9L5 Instructions Manual page 28

y SCOPE button/lamp
Displays/hides the indication of the wave form monitor and vectorscope (☞ "Scope Setting" on page 36).
●
Each time you press this button, the window changes in the following order.
No display
Histogram
u For DT-V9L5: DC lamp / For DT-F9L5: BATT. lamp
When the DC power voltage is being lowered due to the battery consumption, the lamp changes to orange from green. When the voltage
becomes lower than a certain level, the monitor automatically turns off and the lamp turns to red.
For DT-V9L5: Make sure to turn off the POWER switch (☞ 1 on page 28) and DC switch (3 on page 29) on the rear panel before replacing
●
the battery. / For DT-F9L5: Make sure to turn off the POWER switch (☞ 3 on page 29) on the rear panel before replacing the battery.
●
The length of time that the lamp lights in orange differs depending on the type of battery or the battery condition. It is recommended to
replace the battery when the lamp turns to orange.
Carry handle
DT-V9L5
Use this handle when carrying the monitor.
DT-F9L5
Back tally lamp
This lamp is controlled by the tally
function of the MAKE/TRIGGER terminal.
• The setting of the lamp is linked to
the red tally lamp on the front panel.
(☞ "Tally Setting" on page 37 and
"External Control" on page 42)
1 POWER switch (DT-V9L5 only)
Turns AC power on or off.
● button (☞ q on page 27) to use the monitor after turning on the POWER switch.
You need to press
28 28
Wave form monitor
Vectorscope
Attach a security wire to this slot.
Carry handle
Use this handle when carrying the monitor.
(☞ page 26)
Common