Self-Cleaning - Frigidaire Electric Range with Induction Cooktop Use & Care Manual

Setting a self-clean cycle or a delayed
start self-clean cycle
Examples: To start an immediate self-cleaning cycle
and/or how to add a delay start time of 9:00 o'clock
and shut-off self-clean automatically:
Step
1. Be sure the clock is set with the correct
time of day, ALL the oven racks are
removed and the oven door is closed.
Go to step 5 if you wish to start
self-clean immediately.
Finish steps 2 thru 6 if setting a
delayed start self-clean cycle.
2. Press delay start.
3. Enter 9 0 0.
4. Press start.
5. Press self clean once for a 3-hour
clean time, press self clean twice for
4-hour clean and press 3 times
for a 2-hour self-clean cycle time.
6. Press start.
IMPORTANT
As soon as the controls are set, the motor driven door
lock will begin to close automatically. "door Loc" will
appear in the display (See Fig. 1). DO NOT open the
oven door while "door Loc" is on (allow 15 seconds for
the oven door to completely lock).
Once the door has locked "CLn" will appear in the
display indicating the oven will begin the self-clean
process (Fig. 2).
Fig. 1
When the self-clean cycle has completed:
1. The time of day and "Hot" will appear in the display
2. Once the oven has cooled down for about 1 hour and
Press
If it becomes necessary to stop a self-clean cycle
once it has been activated:
1. Press cancel.
2. Allow enough time for the oven to cool and for the
To avoid possible burns use care when opening the oven
door after the self-cleaning cycle. Stand to the side of
the oven when opening the door to allow hot air or
steam to escape.
DO NOT force the oven door open. This can damage the
automatic door locking system. Use caution and avoid
possible burns when opening the door after the self-
cleaning cycle has completed. The oven may still be
VERY HOT.
When the self-clean feature is active you may check the
amount of time remaining in the self-clean cycle by
pressing the
locked until the range has cooled sufficiently. You will
need to allow about 1 additional hour to the time
displayed before you can open the oven door. When the
oven is cool, wipe away any residue or powdered ash
Fig. 2
with a damp cloth or paper towel.
window (See Fig.3).
"Hot" is no longer displayed the "door OPn" message
should appear (Fig. 4). When this message turns off
the oven door may be opened. Use caution and avoid
possible burns when opening the door after the self-
cleaning cycle has completed. The oven may still be
VERY HOT.
Fig. 3
"door OPn" message to appear (Fig. 4). When this
message turns off the oven door may be opened. If a
self-clean cycle was active, then stopped or interrupted
by power failure, it may be necessary to run a self-
clean cycle again to thoroughly clean the oven. Please
be aware that you may need to allow up to four hours
before self-clean can be started again.
CAUTION
NOTES
pad once. The oven door will be

SELF-CLEANING

Fig. 4
35