Erasing An Ebl, Ebl Indication; Erasing Ebl/Vrm Data Boxes; Hiding Ebl/Vrm Data Boxes; Moving Ebl/Vrm Data Boxes - Furuno NAVNET 1722 Operator's Manual

2. RADAR OPERATION
Note: Bearing can be shown Relative to ship's heading (relative) or in reference
to North (True). This setting may be changed by changing the EBL
REFERENCE setting, which is in the RADAR DISPLAY SETUP menu.
See the paragraph "5.2.1 Radar display setup."
2.11.3

Erasing an EBL, EBL indication

Press appropriate EBL soft key and press the [CLEAR] key. The EBL is erased
and its indication becomes blank.
2.11.4

Erasing EBL/VRM data boxes

Press the EBL or VRM soft key associated with the EBL/VRM data box you wish
to erase. Press the [CLEAR] key once or twice to erase the data box.
2.11.5

Hiding EBL/VRM data boxes

Press the ZOOM & D. BOX and D. BOX ON/OFF soft keys to show or hide the
EBL/VRM data boxes.
2.11.6

Moving EBL/VRM data boxes

When an EBL/VRM data box is obscuring a target that you need to see, you can
move it to another location as shown below. This cannot be done when the
EBL/VRM soft keys are shown.
1. Press the [EBL/VRM] key to erase the EBL/VRM soft keys if appears.
2. Using the cursor pad, place the cursor inside the data box you wish to move.
As the cursor enters the box it changes to a "hand." Push the [ENTER] knob,
and the hand changes to a fist, meaning the data box is correctly selected.
3. Use the cursor pad to drag the data box to the location desired and push the
[ENTER] knob.
2-16
.250/
SP
H-UP
EBL1
(Dotted line)
EBL2
(Dashed line)
EBL2 bearing
EBL1
EBL1 bearing
VRM1
R: Relative
T: True
How to measure bearing with the EBL
.125nm
319.9 M
EBL2
359.9 R
330.1 R 234.1 R +
VRM2
0.24nm
-.---nm -.---nm
Active marker is highlighted.
EBL
VRM
EBL1
ON
VRM1
ON
OFFSET
EBL2
ON
VRM2
ON