Clearing Memories - Furuno NAVNET 1722 Operator's Manual

7.7

Clearing Memories

Your equipment has a memory for each of the plotter, radar and sounder
sections. These memories can be cleared to restore the unit to default settings.
The following data are not cleared: Heading adjustment, timing adjustment, MBS
level, tuning point, tuning indication (short, medium, long), dead sector, antenna
type, on time, TX time.
1. Press the [MENU] key to open the menu.
2. Press the SYSTEM CONFIGURATION soft key.
3. Press the SYSTEM SETUP soft key.
4. Press the TEST & CLEAR soft key.
5. Press the MEMORY CLEAR soft key.
6. Use the cursor pad to choose the memory to clear.
7. Press the EDIT soft key.
8. Use the cursor pad to select YES and press the ENTER soft key. One of the
following displays appear depending on the selection made at step 6.
9. Push the [ENTER] knob to clear memory selected.
10. Press the MENU key to close the menu.
11. Turn the power off, and on again.
Note: Though the message "SYSTEM HAS FAILED START UP TEST. PLEASE
CONTACT A LOCAL FURUNO REPRESENTATIVE FOR REPAIR. PUSH ANY
KEY TO CONTENUE" may appear when powering on the display unit
immediately after the clearing memories, there is no problem in fact. Press any
key to continue the operation.
7. MAINTENANCE, TROUBLESHOOTING
DISPLAY UNIT
NO
GPS SENSOR
NO
NETWORK SOUNDER
NO
Memory clear menu
Windows for clearing memory
MEMORY
CLEAR
EDIT
RETURN
7-13